The main component of the receiving unit is a direction coupler. A direction coupler is a radio frequency coupler. This device cannot generate energy of its own that is it is a passive device. The radio frequency coupler helps to control the height of the signal that is the amplitude of the signal. Also the direction of the radio frequency signals in the circuit is controlled with the help of a direction coupler. The direction coupler takes out the signal from the input terminal and drags it to the output terminal. This device can be used with the co axial cables, waveguides etc. the direction couplers form a very important part of the radio frequency circuits. These can either be used separately or with phase shifters, filters, amplifiers, modulators etc. the direction couplers are used in the radio frequency circuits where a particular amount of height of the signal is required. The output of the direction coupler is proportional to the input at its source point. The device couples the signal and gives the output. The height of the coupled signal can be measured by measuring the amplitude of the input signal, the output signal and the coupled signal. The coupling factor of a direction coupler is the ratio of the input power at the source line to the power coupled at the second line.
Another important factor of direction coupler is directivity. The unit of directivity is decibels. For high directivity the characteristic impedance of the load should match to the characteristic impedance of the transmission line. The basic direction coupler is a four port device in which two parallel transmission lines are coupled. The direction coupler couples the power according to the port at which the power is incident. It can also measure the power in a signal which is moving in a transmission line. In a radio frequency transmitter a direction coupler is used with an automatic level control circuit. The purpose of the automatic level control circuit is that it controls the power being produced by the radio frequency power amplifier automatically and accordingly fits the input of the radio frequency amplifier to keep the radio frequency power result to a fixed expected level.
An infra red sensor is also present in the circuit of a satellite radio receiver. The advantage of the sensor is that we can operate the device through a remote control. Along with the infra red sensor other circuits present in the device are band pass filters, low noise amplifiers, intermediate frequency filters, oscillator, frequency synthesizer, random access memory, smart cards, chip sets. Etc. all these circuits perform their particular functions according to their designing. Like a band pass filter allows only a particular band of frequencies to pass and rejecting the others.
Article Source: Article Beam - a service of A1 Web Server Web Hosting
Tymon Hytem has worked in the electronics feild for the past 15 years. He enjoys helping people decide on electronic gadgets from finding the right phone for your business and can help you choose the perfect Background Music for your business needs.
No comments:
Post a Comment